Part 4: Spatial Ability
General Guidelines
In the questions of this section, flat shapes have been folded or rolled or both to make three-dimensional objects.
Practice Question 1:
In this question, there is a drawing of a flat shape. The dotted lines show where the shape must be folded. At the right are four different drawings of three-dimensional objects. Notice that only Object C can be made by folding the flat shape shown in the question. Therefore C is the correct answer.
Practice Question 2:
In this question, there is drawing of a flat shape. There are no indications on the flat shape to show where it’s to be rolled. There are dotted lines where the circles meet the rectangle to show where it’s to be folded. Notice that of the four different drawings on the right, only
Object C can be made by both rolling and folding the flat shape. Therefore C is the correct answer.
In the following questions, only one object can be made from the flat shape by folding or rolling or both.
Work CAREFULLY. You should have enough time to answer each problem. It is to your advantage to ANSWER EVERY PROBLEM. Even if you’re not sure of an answer, make your BEST GUESS, then mark your choice on the answer sheet. You’ll receive one point for each correct answer. Points will not be subtracted for problems you answer incorrectly.
If you finish before time is called, go back and check your work in THIS PART only.
You will have 4 minutes to complete this part.